Easy to use and professional Influenza type A and type B Antigen
Rapid Test with CE
| Product Name |
Influenza type A and type B Antigen Rapid Test |
| Formats | Strip(3mm)Device(4mm) |
| Place of Origen | China |
| Specimen | swab |
| Read Time | 15 minutes |
| Shelf life | 2 years |
| Package | 25 device/box or 50 strip/Box |
| Storage | 2℃-30℃ |
For professional in vitro diagnostic use only
【DIRECTIONS FOR USE】
Allow the test device, reagents, and/or controls to reach room temperature (15°-30°C) before testing.
1. Remove the test Device from the sealed foil pouch and use it as
soon as possible. Bestresults will be obtained if the assay is
performed immediately after opening the foil pouch.
2. Place the Extraction Tube in the workstation. Hold the
extraction reagent bottle upside down vertically. Squeeze the
bottle and let the solution drop into the extraction tube freely
without touching the edge of the tube. Add 10 drops of solution
(Approx. 0.5ml) to the Extraction Tube.
3. Place the swab specimen in the Extraction Tube. Rotate the swab
for approximately 10 seconds while pressing the head against the
inside of the tube to release the antigen in the swab.
4. Remove the swab while squeezing the swab head against the inside
of the Extraction Tube as you remove it to expel as much liquid as
possible from the swab. Discard the swab in accordance with your
biohazard waste disposal protocol.
5. Fit the dropper tip on top of the extraction test tube. Place
the test device on a clean and level surface. Add 3 full drops of solution to the specimen well (S) and then start the timer.
6. Leave the Device in the tube and read results at 10 minutes. Do
not interpret the result after 20 minutes.
Note: Very low concentrations of Flu A and/or Flu B antigen might result
in a weak line
appearing in the test line regions (A and B) after an extended
period of time; therefore, do not read results after 20 minutes.
POSITIVE RESULT:
| POSITIVE: Influenza B Positive: * A colored band appears in the control band
region (C) and another colored band appears in the B band region.
Influenza A Positive: * A colored band appears in the control band
region (C) and another colored band appears in the A line region.
Influenza A+B Positive: * A colored band appears in the control
line region (C) and two other colored bands appear in A line region
and B line region respectively. |
NEGATIVE RESULT:
|
NEGATIVE: One colored band appears in the control band region (C).
No band appears in the test band region (A/B). |
INVALID RESULT:
|
Control band fails to appear. Results from any test which has not
produced a control band at the specified reading time must be
discarded. Please review the procedure and repeat with a new test.
If the problem persists, discontinue using the kit immediately and
contact your local distributor. |
